DM6710 Separation Roller Installation
Goal:
To install the DM6710 separation roller
Note: The Separation Roller is not preinstalled into the scanner when shipped. You will find it in the scanner’s box, separate from the scanner.
Installation:
Step 1: Pull on the scanner cover release and lift the lid to open the scanner.
Step 2: Flip open the double feed prevention roller cover.
Step 3: Align the plastic gear end on the right side of the roller with the gears in the roller compartment. Make sure the flat side of the roller tip is aligned properly with the slot in the scanner.
Carefully insert the gear end into the scanner and angle the roller down into the left side of the compartment.
Step 4: Press gently on the metal bar on the left side to lock the roller in place with the black tab in the compartment.
Step 5: Press gently on the compartment cover to lock in the scanner. Make sure this cover is fully closed as it may break and cause damage to the scanner if it is not properly in place.
Step 6: Close the scanner when you are finished.
Supported Operating Systems: Windows 10 / 8 / 7